|
INSTALLING THE ABSORPOLE  |
1
 Pull out the Absorber
from the Container, by pulling at the Hook. |
 |
| 2
Break off the Double
Pin that is attached to the Hook. |
 |
| 3
Align the two holes
of the Absorber and the Container |
 |
| 4
Push the Double
Pin through the holes from the back – ALL THE WAY. 5 Pull hard on the
Absorber to ensure that the Double Pin is securely locked. |
 |
| 6
Place the hook over
a bar or loop near the ceiling and pull down until the hook snaps into
position. 7 Push the Absorpole
into the wall corrugation. |
The
Absorpole permanently removes moisture from the air via 1.3 Kg of Calcium
Chloride Salt in the upper part of the Absorpole (The Absorber). The salt
attracts moisture in the air and forms a saline solution (The Brine) that
drips down and is collected in the lower part of the Absorpole (The Container). The Calcium Chloride
Brine is non-toxic and non-corrosive. It is similar to very salty seawater.
In case of contact flush eyes with fresh water. Rinse exposed areas of skin
with fresh water. Absorpoles are recyclable
and environmentally friendly. They are made only from PE/PP type plastic and
contain no metal parts.
